Dear customer.

You received a plastic plate, to install in your Supreme DH V5 Upper Link.

This plate is made to improve the assembly in between Upper Link and Rod.

It also prevent any damage on the Upper Link in case of overtorque.

Here are the instructions to install it.

Install your Supreme DH V5 on a bike stand.

Remove the rear wheel.

Remove the fender.

Remove the left number plate.

Now you have access to the Upper Link.

Remove the 2 pinch bolts of the Upper Link.

Now the Upper Link is ready to receive the plate.

Slide the plate from the left side, to place it in the Upper Link.

Plate must slide from the left, through the Upper Link.

Slide the plate until it get centered with the Upper Link.

Push the plate forward, to align the holes with the Upper Link.

Now your plate is installed in the Upper Link, ready to install back the bolts.

Put some threadlock on the Upper Link bolts.

Install the 2 pinch bolts in the Upper Link.

Use a dynamometer wrench, set at 12 N.m

Torque the pinch bolts to 12 N.m

Install back the fender with the inserts.

Place the brake hose on it's guide, along the number plate bracket.

Install back the left number plate.

Install the back wheel, and torque to 12 N.m

Your Supreme DH V5 is ready to get back on track !